Finishing The Installation; Attaching The Fan Blades - Progress Lighting AirPro P250036 Manual De Instrucciones

Finishing the Installation

Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until
it locks in place at the narrow section of the key
holes. (Fig. 12)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure
by tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket
properly sits in the groove in the hanger ball
before attaching the canopy to the bracket by
turning the housing until it drops into place.
7.
Outlet box
Hanger
bracket
Figure 12

Attaching the Fan Blades

Step 1. AInsert the blade through the slot in the
housing. Align the holes in the blade and the fan
motor assembly and secure with the screw and
fiber washer. (Fig. 11)
Screws
Step 2.Repeat these steps for the remaining
blades.
Canopy
Canopy cover
Figure 13
Fiber Blades
washers
Screws