Installing The Battery; Iinstalling The Light Kit And Glass Shade - Progress Lighting AirPro P250036 Manual De Instrucciones

Before starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Step 1. Remove 1 of 3 screws from the posts of
the mounting plate and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Step 2. While holding the LED light kit under
the fan motor assembly, make the 2-pin wire
connections: (Fig. 16)
- White to white
- Black to black
Step 3. Place the key holes in the light kit over
the two screws previously loosened from the
mounting plate. Turn the light kit until the light
kit locks in place at the narrow section of the
key holes. (Fig. 16)
Step 4. Securely tighten the two mounting
screws previously loosened and the one
previously removed.
Step 5. Raise glass shade up against the light kit
and secure it to fan by turning glass clockwise
until snug. DO NOT OVERTIGHTEN.
9. Installing the Light Kit and Glass Shade
installation,
Wire connectors
LED
light kit
Glass
shade
Figure 16

Installing the battery

Install a 12V battery (included) into the remote
control. To prevent damage to the remote control,
remove the battery if not used for long periods.
(Fig. 17)
Mounting
plate
Screws
Figure 17