Hinkley VANTAGE Manual De Instrucciones página 9

REMEMBER
to turn off the power before you begin.
To properly install your ceiling fan, follow the steps below.
trim ring
6 Slip the yoke cover, and canopy onto the downrod. (Fig. 3)
Slide the hanger ball onto the downrod, insert the cross pin through
the downrod and tighten. Tighten the set screw.
7
Feed wires through holes in rubber ball moisture cap and slide cap
down over top of ball. (Fig. 3)
8
Lift ball/downrod/fan into hanger bracket opening.
NOTE: The tab opposite hanger bracket opening should fit in slot
9
on ball. (Fig. 4)
NOTE:
6 feet of lead wire is supplied on the fan for use with
longer downrods.
Cross Pin
Hanger ball
Hook-up (3) Wires
Downrod
Yoke Cover
Top of
Fan Body
Fig. 3
Registration slot
Fig. 4
©2019 Hinkley Lighting, Inc. | hinkley.com
Ball Moisture Cap
Ground Wire
Set screw
Canopy
Trim Ring
07