Packet Data Settings - Nokia N79 Guia Del Usuario

not needed. In an ad hoc network, all devices must
use the same WLAN network
WLAN security mode
●
used: WEP, 802.1x
WPA/WPA2. If you select
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network supports
them.
To enter the settings for the selected security mode,
select WLAN security
Security settings for WEP
WEP key in use
●
privacy (WEP) key number. You can create up to four
WEP keys. The same settings must be entered on the
WLAN access point device.
Authentication type
●
the authentication type between your device and
the WLAN access point device.
WEP key settings
●
of the key), WEP key format (ASCII
Hexadecimal), and
the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of authentication:
●
EAP to use an extensible authentication protocol
(EAP) plug-in, or
Complete the appropriate settings:
164
name.
— Select the encryption
(not for ad hoc networks), or
Open network, no
settings.
— Select the wired equivalent
— Select Open or Shared
— Enter WEP encryption
or
WEP key (the WEP key data in
Pre-shared key to use a password.
EAP plug-in settings
●
your service provider instructs.
Pre-shared key
●
password must be entered on the WLAN access
point device.
WPA2 only mode
●
are allowed to establish a connection in this mode.
Advanced WLAN settings
Select Options
following:
IPv4 settings
●
the subnet IP address, the default gateway, and the
IP addresses of the primary and secondary DNS
servers. Contact your internet service provider for
these addresses.
IPv6 settings
●
for
Ad-hoc channel
●
channel number (1-11) manually, select
defined.
(length
Proxy server address
●
proxy server.
Proxy port number
●
number.

Packet data settings

Press , and select
Connection
>
— Enter the settings as
— Enter a password. The same
— Only WPA2 enabled devices
Advanced settings and from the
>
— Enter the IP address of your device,
— Define the type of DNS address.
(only for Ad-hoc) — To enter a
— Enter the address for the
— Enter the proxy port
Tools Settings
>
Packet data.
User
>