Waste water pump
Large food remnants in the rinsing water not retained by the ilters may
block the waste water pump. The rinsing water does not get pumped out
and covers the ilter.
In this case:
•
Disconnect the appliance from the power supply.
•
Remove the ilters.
•
Scoop out water, use a sponge if required.
•
Using a spoon, pry of pump cover (as illustrated) until it clicks, then grip
the cover by the lug and irst pull it upward until it resists and then pull
it out forward.
•
Check inner compartment and remove any foreign objects.
•
Place cover in the original position, press down and engage.
•
Reinstall ilters.
19
1
3
2
Click
Klick