Camera Parts - Bushnell 111026 Manual

CAMERA PARTS

1. the camera is powered by two AAA alkaline, lithium, or NiMh batteries (not
included). insert batteries into the compartment, with the springs in contact with
the negative (flat) end of each battery. A power meter on the top right of the
display indicates battery condition.
2. insert an SD card ("upside down" with metal contacts facing up) in the slot if
greater storage is desired. You may use SD cards (not MMC cards) up to 32 GB
capacity.
3. Press and hold the MODE button for two seconds to turn on the camera. the
camera will turn off automatically after about 3 minutes if no buttons are pressed.
Note: when the camera is connected to a computer via the supplied USB cable, the
camera will draw power from the computer with no battery drain.
4. Hold the imageView steady and press SNAP to take a picture (or start/stop
shooting a video, when the camera is in video mode). the camera focus is preset
to take sharp photos from approximately 75 feet to infinity.
Using the Optional Operating Modes
Your imageView is already setup to produce high quality results right out of the box,
and it is not necessary to use the optional modes-you may simply press the SNAP
button and start taking photos. However, as you might want to shoot a video clip, delete
one or more previous photos, or explore other options, we recommend you review the
Setup and Basic Operation
6