Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
C. Route guy wires through Gripples
Route each guy wire through a Gripple
and a carabiner on the fan, and then back through the Gripple. Do not
®
tighten the Gripples until all guy wires have been installed.
To back a guy wire out of a Gripple, insert a 1/16" (2 mm) Allen wrench into the small hole on the Gripple.
Gripple
D. Secure guy wires
Over-tightening the guy wires could throw the fan off balance.
Evenly cinch all four guy wires into place using the Gripples. The guy wires should be taut, evenly spaced
around the fan, and away from the path of the airfoils. Maintain a distance of 6" to 8" (152 to 203 mm) between
the Gripples and the carabiners.
Once all of the guy wires are taut and correctly positioned, secure their loose ends with the wire rope clips and
tighten to 4.5 ft·lb (6.1 N·m). Ensure all electrical cords/cables are unobstructed by the guy wire system.
Wire Rope Clip
4.5 ft·lb (6.1 N·m)
18
WWW.BIGASSFANS.COM
© 2018 DELTA T LLC
ALL RIGHTS RESERVED.
Publicidad
Tabla de contenido
