Publicidad
Idiomas disponibles
Idiomas disponibles
3 41 01 165 21 0.book Seite 5 Mittwoch, 7. September 2011 12:05 12
Special safety instructions.
Wear personal protective equipment. Depen-
ding on the application, use a face shield,
safety goggles or safety glasses. Wear ear pro-
tection. The safety glasses must be capable of
protecting against flying particles generated
by the various operations. Prolonged expos-
ure to high intensity noise may cause loss of
hearing.
Secure the power tool with the safety strap
supplied if there is danger of it falling, espe-
cially for work carried out at elevated heights,
when drilling horizontally or above the head. If
there is a power loss, or the power plug is
pulled out, the magnetic holding power is not
maintained.
When working overhead or on vertical sur-
faces, the coolant container must not be used.
Use Slugger Cutting Paste instead. Liquids
penetrating your electric power tool may
cause electric shock.
Avoid touching the drilled core that is automati-
cally ejected by the pilot pin when the working
procedure is finished. Contact with the core
when it is hot, or if it falls, can cause personal
injuries.
Operate the power tool only from grounded
contact sockets that comply with the specifica-
tions. Do not use any connection cables that are
damaged; use extension cables with a groun-
ded contact that are checked at regular inter-
vals. A grounded conductor without
continuity can cause an electric shock.
Do not machine any material containing asbes-
tos. Asbestos is carcinogenic.
To prevent injuries, always keep your hands,
clothing, etc. away from rotating swarf. The
swarf can cause injuries. Always use the chip-
ping protector.
Do not attempt to remove the cutting tool if it
does not turn. This can lead to serious injuries.
Do not rivet or screw any name-plates or signs
onto the power tool. If the insulation is dama-
ged, protection against an electric shock will be
ineffective. Adhesive labels are recommended.
Do not use accessories which are not specifi-
cally designed and recommended by the power
tool manufacturer. Safe operation is not ensu-
red merely because an accessory fits your
power tool.
Clean the ventilation openings on the power
tool at regular intervals using non-metal tools.
The blower of the motor draws dust into the
housing. An excessive accumulation of metal-
lic dust can cause an electrical hazard.
Hold power tool by insulated gripping surfaces
when performing an operation where the cut-
ting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live"
wire will make exposed metal parts of the
power tool "live" and shock the operator.
With a tool inserted, the motor may not move
downward by itself. Readjust hexagonal nut
(790) as required. Before readjusting, pull the
power plug from the socket outlet and
remove the cover (950). Pay attention to the
sensitive electronics below the cover!
See exploded view.
Before putting into operation, check the power
connection and the power plug for damage.
en
5
Publicidad
