Makita GA4540R Manual De Instrucciones página 10

Abrasive cut-off wheel
Thickness: Less than 4 mm (5/32")
1
2
22.23 mm (7/8")
3
1. Lock nut 2. Abrasive cut-off wheel
Operation with wire cup brush
(optional accessory)
CAUTION:
• Check operation of brush by running tool with no
load, insuring that no one is in front of or in line
with brush.
• Do not use brush that is damaged, or which is
out of balance. Use of damaged brush could
increase potential for injury from contact with
broken brush wires.
► 1. Wire cup brush
Unplug tool and place it upside down allowing easy
access to spindle. Remove any accessories on spindle.
Thread wire cup brush onto spindle and tighten with
supplied wrench. When using brush, avoid applying too
much pressure which causes over bending of wires,
leading to premature breakage.
Thickness: 4 mm (5/32") or more
22.23 mm (7/8")
3.
1
Diamond wheel
Thickness: Less than 4 mm (5/32")
1
4
22.23 mm (7/8")
3
Inner flange 4. Diamond wheel
Operation with wire wheel brush
(optional accessory)
CAUTION:
• Check operation of wire wheel brush by running
tool with no load, insuring that no one is in front
of or in line with the wire wheel brush.
• Do not use wire wheel brush that is damaged,
or which is out of balance. Use of damaged wire
wheel brush could increase potential for injury
from contact with broken wires.
• ALWAYS use guard with wire wheel brushes,
assuring diameter of wheel fits inside guard.
Wheel can shatter during use and guard helps
to reduce chances of personal injury.
1
► 1. Wire wheel brush
Unplug tool and place it upside down allowing easy
access to spindle. Remove any accessories on spindle.
Thread wire wheel brush onto spindle and tighten with
the wrenches.
When using wire wheel brush, avoid applying too much
pressure which causes over bending of wires, leading
to premature breakage.
10 ENGLISH
Thickness: 4 mm (5/32") or more
22.23 mm (7/8")