Makita GA4540R Manual De Instrucciones página 7

Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel, multi-
disc, wire wheel brush / abrasive
cut-off wheel, diamond wheel)
WARNING:
• When using a depressed center wheel, multi-
disc or wire wheel brush, the wheel guard must
be fitted on the tool so that the closed side of the
guard always points toward the operator.
• When using an abrasive cut-off / diamond
wheel, be sure to use only the special wheel
guard designed for use with cut-off wheels.
For tool with clamp lever type wheel
guard
1
2
► 1. Wheel guard 2. Bearing box 3. Screw 4. Lever
Loosen the screw, and then pull the lever in the direc-
tion of the arrow. Mount the wheel guard with the protru-
sions on the wheel guard band aligned with the notches
on the bearing box. Then rotate the wheel guard to such
an angle that it can protect the operator according to
work.
1
► 1. Screw 2. Lever
Pull the lever in direction of the arrow. Then tighten the
wheel guard with fastening the screw. Be sure to tighten
the screw securely. The setting angle of the wheel
guard can be adjusted with the lever.
To remove wheel guard, follow the installation proce-
dure in reverse.
For tool with locking screw type
wheel guard
1
2
► 1. Wheel guard 2. Bearing box 3. Screw
3 Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard to such an angle
that it can protect the operator according to work. Be
sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
4
Installing or removing depressed
center wheel or multi-disc (optional
accessory)
WARNING:
• When using a depressed center wheel or multi-
disc, the wheel guard must be fitted on the tool
so that the closed side of the guard always
points toward the operator.
7 ENGLISH
2
3