Descargar Imprimir esta página

Innotek Command Serie Guia De Funcionamiento página 11

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 61
english(eng).qxp
10/27/2005
Troubleshooting
• To manually test the system for proper functioning, attach the test light to the probes of the
collar receiver and press the transmitter button. The test lamp should light to indicate stimula-
tion is being delivered. If the test lamp does not light, refer to the Important Note in Section 1.
• If signals from another transmitter or similar device interfere with your training, change the ID
Code as explained on page ENG-3.
• If your dog seems sometimes to not be receiving the stimulus, the cause could be discharged
batteries, a collar that is too loose or probes of insufficient length. Recharging the collar,
replacing the transmitter battery or adjusting the collar and probes solves these problems.
If you still cannot solve the problem, contact your nearest INNOTEK Service Center.
Important: The perceived stimulation intensity is increased when your dog's hair and skin are
wet. Use a lower level of stimulation when the dog is wet.
For more information, visit our web site at www.innotek.net.
CAUTION FOR BATTERY USE:
• Do not disassemble
• Do not short circuit
• Do not expose to high temperature: 60°C/140°F
• Do not incinerate
• Avoid high humidity
• Keep batteries out of reach of children
Batteries must be recycled or disposed of properly. They should NEVER be placed in munic-
ipal waste. Should it be necessary to remove or replace your unit's battery, your INNOTEK
Service Center will dispose of it according to local regulations.
Intended Use
INNOTEK
®
remote training systems are short-range radio transmitters designed for use in
European countries: AT, BE, CH, DE, DK, ES, FI, FR, GB, GR, IE, IS, IT, LU, NL, NO, PT & SE.
Note that in some countries there could be a limitation of use due to national frequency planning
requirements. The user is responsible for respecting those rules.
This product is in full compliance with the provisions of the R&TTE – Directive 1999/05/EEC. The
Declaration of Conformity can be found at http://www.innotek.net/world.shtml
11:39 AM
Page ENG-11
ENG-11

Publicidad

loading

Este manual también es adecuado para:

Cs-1600yeCs-1600tteCs-300e