Innotek Command Serie Guia De Funcionamiento página 3

english(eng).qxp 10/27/2005
Transmitter Set Up and Programming
Setting Up the Transmitter
Screw the supplied antenna into the port on the top of the transmitter. Install the battery by
removing the battery cover on the back of the transmitter and snapping the supplied 9-volt
alkaline battery into the correct battery terminals.
Setting Up the CS-300E
(for CS-1600E, CS-1600TTE, see next section)
Your CS-300E allows you to administer:
• Stimulation with tone; or
• Stimulation with no tone; or
• Stimulation after tone and a 1.5-second delay
Note: Read Steps 1 and 2 carefully before proceeding. You must begin Step 2 within
10 seconds of completing Step 1.
1. Press the white reset button above the battery (Fig. 1). The light on the face of the transmitter
will glow solid YELLOW.
2. Immediately press one of the buttons in the center column:
• GREEN – Stimulation with tone
• YELLOW – Stimulation with no tone
• RED – Stimulation after tone and a 1.5-second delay
Note: The light will change color to match your selection.
If you do not select a tone option, the system automatically defaults to stimulation with no
tone.
Selecting an ID Code
Setting/Changing the ID Code – You must set an
ID code before first use and whenever you
change the transmitter battery. In the unlikely
event you experience interference from another
INNOTEK trainer in your area, you can simply
change your transmitter's code. To set or change
the ID code:
1. Press the white reset button above the battery (Fig. 1). The light on the face of the transmitter
will glow solid YELLOW.
2. Press and release the round BLUE button in the center column. The light will flash alternating
RED and GREEN several times as it selects an ID code.
Setting Up the Collar Receiver
Install the battery. With the edge of the supplied wrench or a small coin, unscrew the battery
screw cap. Insert the supplied 3-volt lithium battery with the positive terminal (+) facing out.
Replace and tighten the battery screw cap.
11:39 AM Page ENG-3
Fig. 1 – Reset button
ENG-3
RANGE