Test Light Instructions; Terms Of Use And Limitation Of Liability; Caution - Petsafe PIF-300-21 Manual De Adiestramiento Y Funcionamiento

Test Light Instructions

Important: Remove Test Light before placing Receiver Collar on your pet.
Note: If the Test Light does not flash, install a new battery and re-test. If Test Light still does not flash,
Centre.
_____________________________________________________

Terms of Use and Limitation of Liability

1. Terms of Use
This Product is offered to you conditionally upon your acceptance without modification of the terms, conditions and
notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific temperament of your pet may not work
with this Product. We recommend that you not use this Product if your pet is less than 3.6 kg (8 lb) or if your pet is
aggressive. If you are unsure whether this is appropriate for your pet please consult your veterinarian or certified trainer.
Proper use includes reviewing the entire Guide provided with your Product and any specific Caution statements.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm, injure or provoke.
Using this Product in a way that is not intended could result in violation of National or local laws.
4. Limitation of Liability
In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive, incidental, special or
consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this Product.
Buyer assumes all risks and liability from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices under which this Product is
offered.
_____________________________________________________

Caution

The PetSafe Wireless Pet Containment System™ is NOT a solid barrier. The system is designed to act as a deterrent to
remind pets by Static Correction to remain within the boundary established. It is important that you reinforce training
with your pet on a regular basis. Since the tolerance level to Static Correction varies from pet to pet, Radio Systems
Corporation CANNOT guarantee that the system will, in all cases, keep a pet within the established boundary. Not all pets
can be trained to avoid crossing the boundary! Therefore, if you have reason to believe that your pet may pose a danger
to others or harm himself if he is not kept from crossing the boundaries, you should NOT rely solely upon the PetSafe
Wireless Pet Containment System™ to confine your pet. Radio Systems Corporation shall NOT be liable for any property
damage, economic loss or any consequential damages, sustained as a result of any animal crossing the boundary.
1. Set Receiver Collar to Static Correction Level 6.
2. Remove the battery.
3. Loosen the Contact Points with pliers.
4. Bend the leads around the base of each Contact Point.
5. Hand tighten the Contact Points, making sure that the leads stay in contact with the bases of the
Contact Points.
6. Replace the battery.
7. The Test Light will flash in the Boundary Zone if the Receiver Collar is working properly.
8. Remove the Test Light and tighten the Contact Points with pliers one-half turn beyond finger tight.
Save the Test Light for future testing.
www.petsafe.net
contact the Customer Care
15