Control Panel; Fan Speed - Aircare 826000 Guía De Uso Y Cuidado

OPERATION
Plug cord into wall receptacle. Your humidifier is now ready for use. The humidifier
should be placed at least FOUR inches away from any walls and away from heat
registers. Unrestricted airflow into the unit will result in the best efficiency and
performance.
NOTE: This unit has an automatic humidistat located in the control that senses the
humidity level around the immediate area of the humidifier. It turns the humidifier on
when the relative humidity in your home is below the humidistat setting and will turn
the humidifier off when the relative humidity reaches the humidistat setting.

CONTROL PANEL

The 826000 has a two-knob analog
control with a WATER FILL light.
HUMIDITY SETTING.
1) For initial operation, set the humidity
control knob at its midpoint "two-
droplet" setting and adjust up or
down from there to achieve the
desired humidity level.

FAN SPEED

2) The 826000 unit has a 2-speed fan.
Use the low setting for the quietest operation or a high setting for maximum
output. Position the knob at the single fan blade symbol for low and the two-fan
blade symbol for high speed.
NOTE: When excessive condensation exists, a lower speed setting is recommended.
CAUTION: Disconnect power before filling, cleaning or servicing unit. Keep
grille dry at all times.
REFILL INDICATION
When the unit is out of water,
1)
the motor automatically shuts off.
2) At this time unplug and refill unit according to the instructions in the WATER
FILL section.
the red "ADD WATER " light illuminates and
6