Fan Assembly. Pgs - Craftmade PAR52ESP4 Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the
downrod provided to use with an extended downrod
(sold separately). [If you wish to use the downrod
provided, please proceed to instructions following the
dotted line below.]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
Locate canopy cover in hardware pack. Loosen yoke
set screws and nuts at top of motor housing. Remove
pin and clip from motor housing yoke. Slide downrod
through canopy, canopy cover and weatherproof yoke
cover. [Note: Canopy cover must be turned with shiny
side toward the motor housing.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper end
of the downrod.
Thread downrod into the motor yoke until holes for
pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip. Tighten yoke set screws and nuts securely.
Lower weatherproof yoke cover to motor housing.
Remove electrical tape from electrical wiring and
thread each of the wires through a different hole in
the weatherproof hanging ball cover. Thread the
safety cable with the green (ground) wire. Pull
weatherproof hanging ball cover down securely over
hanging ball (on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
A
electrical wiring
hanging
ball
canopy cover
clip
page 4
set screw hole
stop pin
hanging ball
B
safety cable
weatherproof hanging
ball cover
downrod
canopy
weatherproof
yoke cover
yoke set screw
pin
motor
housing