EdilKamin DOUBLE Manual De Instalación, Uso Y Manutención página 14

Removable handles for opening hatch and door
The hatch handle is not fixed to the same hatch but is inserted when required.
The handle is to be inserted in the lower part of the frame, forking it in the appropriate
pegs (fig 1-4).
The handle is only needed to lift or lower the hatch.
The handle to unblock the opening of the door is also removable (fig 1 and 4).
Fuelling air
DOUBLE can only be mounted in rooms with sufficient fuelling air power supply, and must
function closed.
To have the chimney function correctly, it is essential that the fuelling air reaches the
hearth through a fine pipe on the appropriate inlets, provided at the sides and rear of the
chimney.
A fitting with a 125 mm valve to be applied to the inlet to be used ( fig. 5) is supplied.The
connection with the outside must have a useful passage section of at least 125 cm
its path.
In case of use with hearth open, or if the building in which the chimney is installed is
particularly sealed, a supplementary air inlet of a further 120 cm
provided.
Fitting with butterfl y valve
The fuelling air must flow to the hearth regulated by a butterfly valve
The butterfly valve is delivered as an accessory together with a flexible pipe and the fixing
bands. Unless the butterfly valve is mounted in a fixed and solid manner, the chimney
cannot be started.
The mouths not used for connecting the flexible pipe for the fuelling air passage, must
remain closed with a lid.
Mount the fuelling air regulating control in the most adequate position under the threshold.
Regulating the butterfl y valve
„Starting" position / max. heating power:
totally extracted air valve regulating control. Starting with cold chimney and max. hearth power. (fig. 6)
„Maintain fi re" position:
control for regulating the valve completely inserted.All air inlets are closed (fig. 7).
Air for the heating
the room air enters from the side inlets ( n 13 - fig. 2) obtained at the side of the shell, heats up, in contact with the metal hood and exits
from the 2 14cm holes on the lid of the same shell.
Appropriate passages on the covering must be provided so that the room air can reach the above said side inlets.
An aluminium flexible pipe to duct air in near by rooms can be applied, using appropriate fitting, to both 14 diameter holes present on the
shell lid.
two bis kit
chimney room
+ 1 near by rooms
The Edilkamin hearths, as well as heating through radiation, produce hot air which can be duct through flexible pipes, in this way heating
the whole house uniformly.
14
THE TECHNOLOGY
three bis kit
chimney room
+ 2 near by rooms
along
2
useful passages, must be
2
N.B. in case of conveyance of the hot air to rooms different from
the one where the chimney is installed, it is necessary to guarantee
the return of the same air to the chimney room, through a grill at
the base of the walls or through slots under the doors.
AIR DUCTING KITS
To facilitate the realisation of the hot air distribution system,
Edilkamin has provided two kits containing all that necessary for
the two cases, illustrated at the side.
door handle hatchhandle fig. 4
fig. 5
fig. 6
fig. 7