Restoring Factory Settings (Reset); The Seca 360° Wireless Network; Introduction; Seca Wireless Groups - Seca 727 Manual De Instrucciones Y Garantía

Restoring factory
settings (RESET)
7. THE SECA 360° WIRELESS NETWORK

7.1 Introduction

seca wireless groups

66 •
3. Confirm your selection.
You exit the menu automatically.
You can restore the factory settings for the following
functions:
Function
Autohold (AhoLd)
Acoustic signal (PrESS)
Acoustic signal (HoLd)
Attenuation (FiL)
Wireless module (SYS)
Autosend (ASEnd)
Autoprint (APrt)
NOTE
The wireless module is switched off when fac-
tory settings are restored. Information about
existing wireless groups is retained. Wireless
groups do not have to be set up again.
1. Select the "rESEt" item from the menu.
2. Confirm the selection.
You exit the menu automatically.
3. Switch off the scale.
Factory settings are restored and are available
when the scale is next switched on.
This device is equipped with a wireless module. The
wireless module allows measured results to be trans-
mitted wirelessly for analysis and documentation. Data
can be transmitted to the following devices:
• seca wireless printer
• PC with seca USB wireless adapter
The
seca 360° wireless
less groups. A wireless group is a virtual group of trans-
mitters and receivers. If you wish to operate several
transmitters and receivers of the same type, up to 3
wireless groups (0, 1, 2) can be set up.
Factory setting
depending on
model
Off
On
1
Off
Off
Off
network operates with wire-