System Troubles - Gemini GEM-P400 Manul De Operacion



System Troubles

The GEM-P400 is constantly monitoring its own components, as well as all critical services, such as AC power and the telephone
line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble does occur , it will
caution you by lighting the TROUBLE
If you cannot immediately clear the system trouble, the system can still be used. Simply press

trouble as described below, and then arm the system.
To determine the nature of the trouble, press
of the illuminated zone. Refer to the following table to determine the cause of the trouble. If there is more than one trouble to view,

pressing will scroll to the next trouble, and then exit the TROUBLE
Keypad Beeps or Zone light System Trouble
ON
Flashes
1 Beep 1 AC Power Failure
1 Beep
2 Low Battery
1 Beep 3 Communication
Failure
1 Beep 4 Telephone Line Cut
2 Beeps 1 Bell/Siren Trouble
Oi230a
page 11
 
light and beeping the keypad buzzer.

followed by
Condition
This trouble will occur if AC power is not present. Make sure system transformer is
plugged into AC receptacle and check the circuit breaker, otherwise call installing
company for service.
If there has been a recent power failure, the battery may be partially depleted and
must be recharged by the control panel. If the trouble does not go away in 24 hours,

call installing company for service.

The system was not able to report to central station. If this is due to a temporary inter-
ruption in the telephone service, the trouble can be cleared when the service is re-
stored by pressing
pressing to exit.
The telephone line has failed. If telephone service has been temporarily interrupted,
the trouble will clear it is when restored. Otherwise, call installing company for service.
There is a problem with the Bell or Siren. Call installing company for service.

followed by

, count the number of keypad beeps and observe the number
mode if there are no more troubles to view.
Action
followed by again to view the trouble, and and then
Otherwise, call installing company for service.
to view the
11
Tuesday, September 16, 1997 08:26