Gemini GEM-P400 Manul De Operacion página 290

About the AutoFill pitcher
WARNING
To reduce the risk associated with choking, do not allow children less than 3 years of age to have access
to small parts during the installation of this product.
pitcher for a constant supply of fresh water. The refrigerator
shelf must be at the second position to use the AutoFill pitcher.
1. Place the lid onto the pitcher so it fits securely. Align the
notch in the pitcher lid to the dispenser guide in the top of
the refrigerator and slide the pitcher toward the back of
the refrigerator until it stops.
Notch in top
of pitcher
Shelf at second
position
The Water Filter is located on the underside of the dispenser
the bypass plug in place when using the AutoFill Pitcher.
To remove
holder. DO NOT TWIST THE FILTER.
45°
1
2
To replace
bypass plug straight into the opening and continue to push as
check to ensure it is properly aligned and fully seated into the
holder.
cause water to drip from the dispenser.
(about 5 minutes) to remove air from the system.
6
(on some models)
Dispenser guide
Holds water
filter or bypass
plug in place
Water filter or
bypass plug holder
.
2. Water will fill the pitcher until it reaches a specified level and
will then shut off.
NOTE: If you remove the pitcher before the water stops,
water may drip on the shelf.
When you replace the pitcher back under the dispenser, it
will refill the pitcher back to the specified level.
NOTE: It is normal for water to appear discolored during the
Reset
Filter Change button for 3 seconds. The
Filter Status.
at
Accessories at 877.959.8688.
Water filter
snaps into
place
2
Water filter or
bypass plug
1
holder
Key slots
1
Key
(both sides)
or call GE Appliances Parts and
Press and
hold to reset
water filter
status