Drawer Removal; Cover Removal - Gemini GEM-P400 Manul De Operacion

Tabla de contenido

Publicidad

About storage drawer and cover removal.
Not all features are on all models.
About the automatic ice maker
A newly-installed refrigerator may take 12–24 hours to begin making ice.
Ice maker
OFF
ON
Feeler Arm
Power Switch
Humidity Controlled Drawer
Slide the control all the way to the
HIGH setting to provide high humidity
recommended for most vegetables.

Drawer Removal

Drawers can be removed easily by grasping
the sides and lifting up slightly while pulling
drawers past the stop location.

Cover Removal

To remove:
Remove the drawers.
Reach in, push the back of glass cover up,
and at the same time, pull it backward as
far as it will come.
Tilt it and take it out. Avoid cleaning the cold
glass cover with hot water because the extreme
Remove the drawer frame. (Always remove
the glass cover before you take out the
drawer frame.)
CAUTION
Avoid contact with the
moving parts of the ejector mechanism, or
with the heating element (located on the
bottom of the ice maker) that releases the
automatic ice making mechanism while the
refrigerator is plugged in.
Automatic Ice maker (on some models).
The ice maker will produce approximately
70-100 cubes in a 24-hour period, depending
on the freezer compartment temperature, room
temperature, number of door openings and other
use conditions.
If the refrigerator is operated before the water
connection is made to the ice maker, set the
switch OFF.
When the refrigerator has been connected to the
water supply, set the switch ON position.
15°F. A newly-installed refrigerator may take 12 to
24 hours to begin making ice cubes.
(on some models)
Slide the control all the way to the LOW
setting to provide lower humidity levels
recommended for most fruits.
back, pull it forward, tilt it and take it out.
To replace:
Lower the frame until it rests on the
supports at each side and back.
Replace the glass cover, pushing its front
and gently lowering the back into place.
Replace the drawers.
Once the ice maker starts to make ice, it may take
temperature settings and number of door openings.
You will hear a buzzing sound each time the ice
NOTICE:
to allow the water line to clear.
Be sure nothing interferes with the sweep of the
feeler arm.
ice maker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale, shrink or fuse together.
Ice maker accessory kit:
If your refrigerator did not already come equipped
with an automatic ice maker, an ice maker
accessory kit is available at extra cost.
ice maker kit needed for your model.
GEAppliances.com
5

Publicidad

Tabla de contenido
loading

Tabla de contenido