Rinse Aid Dispenser - Kenmore ULTRA WASH 665.15762 Manual De Uso Y Cuidado

Filling the dispenser
1. If the dispenser cover is closed, open the cover by pushing
the Cover latch.
2. Fill the Main Wash section with detergent. See "How Much
Detergent to Use."
& Close the Main Wash dispenser cover. Fill the Pre-Wesh
section if needed.
It is normal for the cover to open partially when dispensing
detergent.
NOTE: Use both sections for cycles with 2 washes. Use only the
covered section for cycles with 1 wash. See the "Cycle Selection
Chart" for more details.
How much detergent to use
• The amount of detergent to use depends on the hardness of
your water and the type of detergent. If you use tee little,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
• Water hardness can change over a period of time. Find out
your water's hardness by asking your local water department,
water softener company, or county extension agent.
• Different brands of dishwasher detergent have different
amounts of phosphorus for softening water. If you have hard
water and use a detergent with a phosphorous content of
less than &7%, you might need to use more detergent, or use
a detergent with a phosphorous content higher than 8.7%.
Where to fill
Top of 3rd step (3 tbs or 45 g)
Top of 2nd step (2 tbs or 30 g)
Top of let step (1 tb or 15 g)
Water Hardness Amount of Detergent
Soft to Medium For normally soiled loads
Hard Water • Fill the Main Wash section to the
0 to 6 grains per top of the 2nd step (2 tbs or 30 g)
gallon • Fill the Pre-Wesh section to the
top of the 2nd step (2 tbs or30 g)
if needed
NOTE: Add only 1 tb or 15 g of
detergent to both sections if dishes
are pre-rinsed or the water is very
soft (0 to 2 grains per gallon).
For heavily soiled loads
• Fill the Main Wash section to the
top of the 3rd step (3 tbs or 45 g)
• Fill the Pre-Wesh section to the
top of the 2nd step (2 tbs or 30 g)
Medium to Hard For normally soiled and
Water heavily soiled loads
7 to 12 grains per • Fill the Main Wash section to the
gallon top of the 3rd step (3 tbs or 45 g)
•
Fill the Pre-Wesh section to the
top of the 2nd step (2 tbs or30 g)
if needed
NOTE: Fill amounts shown are for standard powdered detergent.
Amounts may vary if you use liquid or concentrated powdered
detergent. Follow instructions on the package when using liquid
dishwasher detergent or concentrated powdered detergent.
Rinse Aid Dispenser
Rinse aids prevent water from forming droplets that can dry as
spots or streaks. They also improve drying by allowing water to
drain off of the dishes during the final rinse by releasing a small
amount of the rinse aid into the rinse water Your dishwasher is
designed to use a liquid rinse aid. Do not use a solid or bar-type.
Checking the dispenser
Check the center of the Fill Indicator cap. Clear means it needs
filling.
OR
Or you can remove the Fill Indicator cap. If an "E" is visible, the
dispenser is empty.
Filling the dispenser
The rinse aid dispenser holds 6 oz (175 mL) of rinse aid. Under
normal conditions, this will last for about three months. You de
not have to wait until the dispenser is empty to refill it. Try to keep
it full, but be careful not to overfill it.
1. Make sure the dishwasher door is completely open.
2. Remove the Fill Indicator cap.
& Add rinse aid. Fill to the smallest opening in the lower part of
the dispenser. Overfilling can cause the rinse aid to leak Out,
and could cause eversudsing.
4. Clean up any spilled rinse aid with a damp cloth.
5. Replace the Fill Indicator cap. Close tightly.
11