Ultra Wash _ Soil Removal System; Start-Up Guide; Using Your New Dishwasher - Kenmore ULTRA WASH 665.15762 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

R@movall
The ULTRA WASH SOIl removal system
gives you sparkling
clean
dishes,
while using lees energy and time. The ULTRA WASH soiI
rernovei system
includes:
A heavy-duty grinder that acts as a food disposer to grind
and dispose of targe food particles.
An ULTRA WASH sensor to monitor soil tevei and adjust the
cycles as needed,
An Automatic
Temperature Control (ATC) that ensures the
proper water temperature for the selected wash cycle, and
soi! level of the Iced,
How the ULTRA WASH soil removal
_stem
works
1.
Load the dishwashe_
Remove bones, large chunks or
burned-on
food. No rinsing is necessary. Any remaining food
soil will be ground up and disposed down the drain with the
rinse wate_
2.
Hot water fills the dishwasher to a level near the bottom of
the overiill protection float.
&
The HEATING indicator glows, and the dishwasher pauses
while the water is heated,
4. When the water reeches the proper temperature,
the
HEATING indicator turns off and the cycte resumes.
&
Detergent from the detergent dispenser is dispensed at the
correct cycle times and hot water is pumped through the
ULTRA WASH pump,
6.
Hot water and detergent sprays against the soiled surfaces of
the load and removes food particles,
7.
Food soil is held in an accumulating
chambe_
8.
Food soil is disposed down the drain with the wash water.
9.
Fresh, hot water enters the dishwasher and sprays on the
dishes, The rinse water is then pumped through the
ULTRA WASH soil removal system and remaining sol!
is removed.
10. The food soil that is held in the ULTRA WASH soil removal
system is disposed down the drain with the rinse water.
11. The final rinse water is heated. The rinse aid is added to the
water for the final rinse to prepare the dishes for drying,
How the ULTRA WASH Sensor and the Automatic
Temperature Control _TC) work
1. The ULTRAWASH Sensor measures the amount of sol! in the
dishwashe_
2. After the soil levet is determined,
unnecessary portions of the
cycle are skipped,
3. The ATC adjusts the water temperature throughout
the cycle
depending
upon the soil level detected, Higher water
temperatures
are used to improve cIeaning with heavier
soiled loads,
START-UP GUIDE
Before using your dishwasher, remove all packaging
materials.
Read this entire Use and Care Guide. You will find important
safety information
and useful operating tips.
1. Scrape large food soil and hard items (toothpicks or bones)
from dishes.
2.
Properly load the dishwashea (See "Dishwasher Loading.")
Make sure nothing prevents the spray arm(s) from spinning
freely.
3. Add detergent and checkthe
rinse aid dispenser. Add rinse
aid if needed. (See "Dishwasher Use,")
4.
Push door firmly closed. The door latches automatically.
Run
hot water at the sink nearest your dishwasher
until the water
is hot, (See "Dishwasher Efficiency Tips,") Turn off wate_
5.
Press the desired cycle and option selections, (See
"Dishwasher
Use.") Press START. Qr press START to repeat
the same cycle and options as the previous cycle,

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido