Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Operating guidelines
Uni-auto V die head
Threading instructions
1. Turn the die head support block, which is located
on the carriage, to the left as shown in the diagram
opposite.
2. Attach the appropriate die head as shown in the
photograph.
3. Push the cam plate handle forward to set the auto-
open lever, then set the thread size by fitting the
lever nut to the appropriate position.
Die head support block
4. Set the speed change lever according to the size of
the pipe.Turn the oil flow selector lever to the right
as shown in the diagram.
5. Switch on the machine and the thread cutting oil
will flow from the die head automatically. Excessive
oil flow can be reduced by turning the lever to the
left again.
Fig. 9
Oil flow selecter lever
Fig. 10
Speed change plate
6. Turn the carriage handle clockwise until the
dies have engaged the pipe for 3 or 4 threads.
From this point on, you can release the carriage
handle. A standard taper thread will then be cut
automatically.
40
Speed change lever
Fig. 11
Fig. 12
Fig. 13
Publicidad
