Electrical Connections - Wiring Diagrams - Lamborghini Caloreclima TREND 28 MBS W TOP Manual Para La Instalación Y El Mantenimiento

31

ELECTRICAL CONNECTIONS - WIRING DIAGRAMS

The boiler must be connected to an earthed, single-phase 230V-50 Hz mains supply by means of a three-wire
cable, ensuring that connections to the LINE and NEUTRAL terminals are made correctly.
A bipolar switch must be used with contacts opening to at least 3 mm.
The power lead must only be replaced by another with the following characteristics: "HAR H05 vv-F" 3 X 1.00
mm . (You are strongly advised to use original LAMBORGHINI accessories and spare parts only).
2
Installation must be made in compliance with safety REGULATIONS IN FORCE.
Make a good earth connection.
Protection Noise level
Absorbed power
Voltage Voltage
index dB (A)
kW
32 MBS
V Hz 28 MBS
IP
230 50 0,160 47
X4D
0,153
To gain access to the electrical panel which houses the power
supply terminal block and any connection to a room
fig.2
thermostat, proceed as follows:
● Disconnect the boiler power supply;
● Remove the boiler front panel pulling the handles (fig.1)
● Remove the boiler cover pulling upwards (fig.2)
● To gain access to the electrical and electronic
components loosen screws C of the cover B (Fig. 3)
fig.1
fig.3
B
C