Operation; Initial Operation; Switch On/Off - Protool VCP 260 E-L AC Manual De Instrucciones

- Do not damage the mains power cable
(e.g. by driving over, dragging, etc.).
Protect from heat, oil and sharp edges.
Do not pull the plug from the socket by
the cable.
- Check the plug and the cable regularly
and have them replaced by an authorised
service workshop should either become
damaged cable with the type specifi ed in
the spare parts list. Always replace the
mains power cable with the type specifi ed
in the spare parts list.
- Do not expose the machine to rain.
- The machine should only be used by ap-
pointed persons instructed in correct ma-
chine handling.
- Before use, operators shall be provided
with information, instruction and train-
ing for the use of the machine and the
substances for which it is to be used, in-
cluding the safe method of removal and
disposal of the material collected.
- For reasons of safety, never operate the
machine from an unearthed socket.
- Always use the machine socket for the
purpose specifi ed in the manual.
- Always use original PROTOOL accesso-
ries.
- Pull the plug from the socket when the
machine is not in use and prior to main-
tenance and cleaning work.
- Do not lift or transport the machine by
the handle using a crane or lifting gear.
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of
the power source must correspond with
the specifi cations on the machine's name
plate.

6.1 Initial operation

Open the locking clips [2-2] and remove the
top section of the machine [2-1].
Remove the accessories from the dust con-
tainer [2-3] and the packaging!
Insert the sealing plug [1-15] into the suc-
tion opening [1-1] (for dust class M only).
Insert a fi lter or disposal bag in the dirt trap
(see chapter 7.6 and 7.7).
Replace the top section [2-1] and close the
locking clips [2-2].
Fit the accessory box to the back of the
vacuum cleaner.
Connect the suction hose to the machine.
Accessory box
Hook the accessory box onto the upper
section [2-1] and fasten in place with two
screws [2-5].
The accessory box is equipped with a pipe
holder which has space for three pipes.
If the pipe holder is not needed, it can be
removed without the use of tools: Lift the
latch, tip the pipe holder backwards and
remove it – see fi gure [2].
The suction pipe with the fl oor tool fi tted
can be easily stored in the groove on the
accessory box. The adapter on the pipe
must be fastened in the correct position
– see fi gure [2].

6.2 Switch on/off

► Insert the plug into an earthed socket.
WARNING
Risk of injury from tools starting up
unexpectedly
Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con-
nected tool is switched off.
The switch [1-9] serves as an on/off switch.
Switch position "0"
Appliance socket [1-3] is disconnected from
the power, mobile dust extractor is switched
off.
"MAN" switch position
Appliance socket [1-3] is connected to the
power, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-3] is connected to the
power, the mobile dust extractor starts
when the connected tool is switched on.
17