Oakley DETONATOR Manual De Instrucciones página 4

04 DETONATOR INSTRUCTION MANUAL
SYNCHRONIZING THE ALARM
The small lower dial face shows the alarm time setting. Before the alarm is used for the first
time, it must be synchronized with the current time. The instructions under "SETTING THE
DATE AND TIME" will achieve this. If the main hands of the watch are reset to adjust for the
current time, the alarm hands must be synchronized again by doing the following:
A
POS 1
B
TO RESET THE WATCH TIME AND
SYNCHRONIZE THE ALARM:
1. When the hand in the small dial face at the left
reaches the zero position (points straight up),
pull the crown out to the second click position.
2. Turn the crown to reset the watch to the
current time. When setting the minute hand,
advance the hand to 5 minutes or more past
the desired time, then turn it back to the
desired time.
POS 2
3. Press button (b) repeatedly to advance the
alarm hands to the current time. Press and hold
button (b) to advance the alarm hands rapidly.
4. Push the crown back in to the normal position.
[SYNCHRONIZING THE ALARM CONT. ON NEXT PAGE]
W H E N S E T T I N G T H E T I M E A N D
SYNCHRONIZING THE ALARM, NOTE
THE FOLLOWING
• If the date also needs to be reset, use the
instructions under "SETTING THE DATE AND
TIME" instead of the instructions to the left.
• The watch will resume running when the
crown is pushed back in to the normal
position, so use this to set the watch time to
the precise second of current time.
• Pulling the crown out to the second click
position will automatically reset the
chronograph hand to zero.
DETONATOR INSTRUCTION MANUAL 05
SYNCHRONIZING THE ALARM (cont.)
A
POS 1
B
POS 2