Faber CAMINO PRO Serie Instrucciones De Instalación página 41

INSTALLATION AVEC CANALISATION EN HAUT POUR HOTTE À 2 MOTEURS
1
Placez les deux moteurs dans le bâti de la hotte. À l'intérieur de la hotte, il y a un séparateur de
support de ventilateur. Les moteurs seront de part et d'autre.
2
Installez les deux moteurs aux côtés du support de ventilateur à l'aide des 4 vis 12e fournies.
3
Extrémité à
9 orifices
B
FIGURE 15
3. Attach the blower bracket divider inside the hood, with the 2
screws into the top of the hood and 2 screws into the back, all
supplied with the blower kit (FIGURE 16)
FIGURE 16
4. Install the 2 motor kits into the sides of the blower bracket using
the 4 screws supplied with the motor kit. (FIGURE 17)
5. Connect the wire (FIGURE 18) that comes with the motor kit
from the side of the two motors to the connection on the inside
of the light panel in the hood. The two - 9 hole ends of the wire
are installed in the two motors, the 6 hole end is connected to
the light panel (FIGURE 11 on the previous page)
FIGURE 17
Extrémité à
9 orifices
FIGURE 18
6. Install the 2 dampers on top of the hood. If you want one 10"
round duct to come out of the top of the hood, use the transition
piece (FIGURE 19) that comes with the motor kit and install with
four screws. If you want to use 2 seperate 6" round ducts, do not
Branchez l'extrémité à 9 orifices du câble
use the transition.
au moteur gauche et l'autre extrémité à
7. Attach the hood to the cabinet using (12) 9c. screws to the
9 orifices du câble au moteur droit.
cabinet. FIGURE 20
8. Follow steps 6 - 9 on the previous page to connect ducting,
wiring, and test the electrical connection.
wiring, and test
Extrémité à
9 orifices
41
FIGURE 19
FIGURE 20