Descargar Imprimir esta página

Vimar etvax EG30/N Manual Para El Conexionado Y El Uso página 25

Accionador de cadena para automacion ventanas

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 54
Wiring diagram - wiring for two motor
THIS SYMBOL IDENTIFIES THE TOPPEL ECTRICAL
ACTUATOR IN WIRING DIAGRAMS.
THE SUPPLY VOLTAGE TO WHICH THE ACTUATOR IS TO BE CONNECTED MUST BE ACCORDING TO THE REQUIREMENTS FORSEEN
BY THE LAWS IN FORCE IN THE COUNTRY WHERE THE INSTALLATION IS BEING CARRIED OUT AND MUST SATISFY THE TECHNICAL
CHARACTERISTICS DESCRIBED ON PAGE 4.
THE SECTION OF THE MAINS CABLES MUST BE PROPERLY SIZE DACCORDING TO THE ABSORBED ELECTRIC POWER.
ANY TYPE OF ELECTRIC MATERIAL (PLUG, CABLE, TERMINALS, ETC.) USED FOR THE CONNECTION MUST BE SUITABLE FOR THE USE,
WITH "CE" MARkING AND COMPLYING WITH THE REQUIREMENTS FORESEEN BY THE LAWS IN FORCE IN THE COUNTRY OF INSTAL-
LATION.
TO ASSURE A CORRECT SEPARATION FROM THE MAINS, IT IS COMPULSORY TO INSTALL UP STREAM OF THE DEVICE A BIPOLAR
TEMPORARY SWITCH (PUSH-BUTTON) OF APPROVED TYPE. UP STREAM OF THE CONTROL LINE, IT IS COMPULSORY TO INSTALL AN
UNIPOLAR CUTOUT SWITCH WITH CONTACT OPENING OF AT LEAST 3mm.
BEFORE PERFORMING THE ELECTRIC CONNECTION OF THE ACTUATOR, VERIFY THAT THE POWER SUPPLY CABLE IS NOT DAMAGED.
SHOULD IT BE DAMAGED, IT MUST BE REPLACED BY THE MANUFACTURER OR BY THE TECHNICAL ASSISTANCE SERVICE OR IN ANY
CASE BY AUTHORIZED OPERATORS.
CONTROL DEVICES
THE CONTROL DEVICES USED TO DRIVE THE ACTUATOR MUST ASSURE THE SAFETY CONDITIONS FORESEEN BY THE
LAWS IN FORCE IN THE COUNTRY OF USE.
According to the different type of installations, the actuators can be driven by the following control devices:
1) MANUAL PUSH-BUTTON:
Bipolar switch button with central OFF position, with biased-off switch;
2) CONTROLAND FEEDING UNIT
Microprocessor control units controlling the single actuator or more than one actuator simultaneously by means of one or more manual push-buttons, a
433Mhz radio control. To these control units, it is possible to connect the rain sensors, thewind sensor and the brightness sensor;
THE USED UNITS MUST SUPPLY A VOLTAGE TO EG30 FOR MAX. 120s.
EN
EG30
BROWN
BLACk
GREY
(LIGHT BLUE)
EG30
CLOSES
OPENS
23

Publicidad

loading

Este manual también es adecuado para:

Etvax eg30/n2Etvax eg30/g