[] Connecting Cabtetv - Samsung 3 Serie Manual De Usuario

Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
1, Plug the incoming cable into the ANT IN terminal on the back of the TV.
Because thisTVis cable-ready, youdonotneeda cableboxto viewunscrambled cablechannels.
Connectinq to a Cable Box that Descrambles All Channels
1, Find the cable that is connected to the ANT OUT terminat on your cabte box.
:_ This terminal m ightbe labeled"ANTOUT","VHFOUT"or simply,"OUT".
2, Connect the other end of this cable to the ANT IN terminal on the backof the TV.
NTIN ANTOUT_=
Connectinq to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You wilt need a two-
way splitter, an RF (A/B) switch and four lengths of RF cable. (These items are available at most electronics stores.)
1, Find and disconnect the cable that is
connected to the ANT IN terminal on your
cable box.
:_ This terminalmightbe labeled"ANTIN",
"VHFIN"or simply,"IN".
2, Connect this cable to a two-way splitter.
Incoming
cable
3, Connect an RF cable between the OUTPUT
terminal on the splitter and the IN terminal
on the cable box. Incoming
cable
Splitter
,===_
J
Cable BOX
4, Connect an RF cable between the
ANT OUT terminal on the cable box and
the B-IN terminal on the RF(A/B) switch.
incoming
cable
Splitter
Cable BOX
5, Connect another cable between the other
OUT terminal on the splitter and the A-IN
terminal on the RF (A/B) switch.
Incoming
cable
RF (A/B)
Cable Box Switch
°. onne tthe,ost ,,e,et ee t,e
OUT terminal on the RF (A/B) switch and _ _ A,T_,
the ANT IN terminal on the rear of the TV. _ _i_-7 _ . @
Incoming .... ,11.... TV Rear
1'70_: 'g s_ _ _ _ _ I
/ Cab,_Oo× Sw,_ch I
After you have made this connection, set the A/B switch to the "A" positionfor normal viewing. Set the A/B switchto the "B" position to
view scrambled channels. (When you set theA/B switchto "B",you will need to tune your TV to the cable box's output channel,which is
usually channel 3 or 4.)