Declaracion De Conformidad - York PASA 12 Serie Manual De Usuario E Instalacion

DECLARACION DE CONFORMIDAD

Type of Equipment Air Conditioners
Brand Name YORK
Portable type, 60Hz
Type Designation
PASA12FD-AKA
The product complies with the requirements in UL 484 and CAN/CSA C22.2 No. 117.
We have internal production control system that ensures compliance between the manufacturer products and the technical documentation.
We declare under our sole responsibility that the equipment follows the provisions of the Directives stated above.
Authorized Representative:
Suriya Sittidamrong
Senior Technical Support Engineer
YORK Industrial Thailand
49/40 Moo 5 Tumbol Tungsukhla, Amphur Sriracha, Chonburi 20230 Thailand.
Telephone: (+66) 3849 3400
Fax: (+66) 3849 3421-2
This product contains refrigerant under pressure, rotating parts, and electrical connections which may be a danger and cause injury!
All work must only be carried out by competent persons using suitable protective clothing and safety precautions.
Read the Manual
1. Isolate all sources of electrical supply to the unit including any control system supplies switched by the unit. Ensure that all points of electrical and
gas isolation are secured in the OFF position. The supply cables and gas pipework may then be disconnected and removed. For points of
connection refer to unit installation instructions.
2. Remove all refrigerant from each system of the unit into a suitable container using a refrigerant reclaim or recovery unit. This refrigerant may then be
reused, if appropriate, or returned to the manufacturer for disposal. Under no circumstances should refrigerant be vented to atmosphere.
Where appropriate, drain the refrigerant oil from each system into a suitable container and dispose of according to local laws and regulations
governing disposal of oily wastes.
3. Packaged unit can generally be removed in one piece after disconnection as above. Any fixing down bolts should be removed and then unit lifted
from position using the points provided and equipment of adequate lifting capacity. Reference MUST be made to the unit installation instructions
for unit weight and correct methods of lifting. Note that any residual or spilt refrigerant oil should be mopped up and disposed of as described
above.
4. After removal from position the unit parts may be disposed of according to local laws and regulations.
DECLARATION OF CONFORMITY
INSTALLATION, REMOVAL AND DISPOSAL
Risk of electric shock Unit is remotely controlled and
may start without warning