Maintenance; Td Cartridge Replacement - Olivetti d-Copia 120D Manual De Instrucciones

7
This chapter describes how to replace the TD cartridge and drum cartridge, and how
to clean the unit.
Be sure to use only genuine Olivetti parts and supplies.

TD CARTRIDGE REPLACEMENT

The TD cartridge replacement required (
needed. For more information on purchasing the TD cartridge, see "ABOUT
SUPPLIES AND INTERFACE CABLES" (p.71). If copying is continued while the
indicator is lit, copies will gradually become lighter until the unit stops and the
indicator begins blinking. Replace the old TD cartridge by following the procedure
below.
• After the unit stops, it may be possible to make a few more copies by
• During long copy run of a dark original, the start (
1
Open the side cover and front cover, in that order.
To open the side cover and front cover, see "INSTALLING THE TD
CARTRIDGE" (p.10).
2
Gently pull the TD cartridge out
while pressing the lock release
button.
Dispose of the old TD cartridge in accordance with local regulations.
3
Install a new TD cartridge. To install the new cartridge, see
"INSTALLING THE TD CARTRIDGE" (p.10).
58

MAINTENANCE

taking the TD cartridge out of the unit, shaking it horizontally, then
reinstalling it. If copying is not possible after this operation, replace the
TD cartridge.
blink, the indicator light up, and the unit stop, even though toner is left.
The unit will feed toner up to 2 minutes and then the start (
indicator will light up. Press the start (
) indicator will light up when toner is
) key to restart copying.
Lock release button
) indicator may
)