Craftsman WEEDWACKER Manual Del Usuario página 3

• Adjust the D-handle to your size in order to provide the best grip.
• Be sure the cutting attachment is not in contact with anything
before starting the unit.
• Use the unit only in daylight or good artificial light.
• Avoid accidental starting. Be in the starting position
whenever pulling the starter rope. The operator and unit must
be in a stable position while starting. Refer to
Starting/Stopping Instructions.
• Use the right tool. Only use this tool for its intended purpose.
• Always hold the unit with both hands when operating. Keep a
firm grip on both handles or grips.
• Keep hands, face, and feet away from all moving parts. Do not
touch or try to stop the cutting attachment when it rotates.
• Do not touch the engine, gear housing or muffler. These parts get
extremely hot from operation, even after the unit is turned off.
• Do not operate the engine faster than the speed needed to
cut, trim or edge. Do not run the engine at high speed when
not cutting.
• Always stop the engine when cutting is delayed or when
walking from one cutting location to another.
• If you strike or become entangled with a foreign object, stop the
engine immediately and check for damage. Do not operate
before repairing damage. Do not operate the unit with loose or
damaged parts.
• Turn the engine to off and disconnect the spark plug for
maintenance or repair.
• Use only replacement parts or accessories recommended for
this tool that are distributed by Sears or a Craftsman outlet.
Use of any replacement parts or accessories purchased
elsewhere may be hazardous, and will also void your warranty.
• Keep unit clean of vegetation and other materials. They may
become lodged between the cutting attachment and shield.
• To reduce fire hazard, replace a faulty muffler and spark
arrestor. Keep the engine and muffler free from grass, leaves,
excessive grease or carbon build up.
OTHER SAFETY WARNINGS
• Never store the unit with fuel in the tank, inside a building
where fumes may reach an open flame (pilot lights, etc.) or
sparks (switches, electrical motors, etc.).
• Allow the engine to cool before storing or transporting. Be
sure to secure the unit while transporting.
• Store the unit in a dry place, secured or at a height to prevent
unauthorized use or damage. Keep out of the reach of children.
• Never douse or squirt the unit with water or any other liquid.
Keep handles dry, clean and free from debris. Clean after
each use, see Cleaning and Storage instructions (p. 11).
• Keep these instructions. Refer to them often and use them to
instruct other users. If you loan this unit to others, also loan
them these instructions.
SAVE THESE INSTRUCTIONS
• SAFETY & INTERNATIONAL SYMBOLS •
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the
operator's manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
• SAFETY ALERT SYMBOL
Indicates danger, warning Or caution. May be used
in conjunction with other symbols or pictographs.
wARNING : READ OPERATOR'S MANUAL
ill I lID
Read the operator s manual(s)and fol!ow all warnings
and safety instructions, Failureto do so Can result in
serious injury to the Operator and/oi bystanders:
WEAR EYE AND HEARING PROTECTION
i_ WARNING: Thrown objects and loud noise can
cause severe eye injury and hearing !ossl Wear
eye protect on meeting ANSI Z87:1 standards
and ear protection when operating this unit. Use
a full face shield when needed.
UNLEADED FUEL
_'_ A!waYS use clean, fres h unleaded fue!
_ •OIL
_ Refer to operat0r's manual for the p[0per type 0f OiL
' SHARP BLADE
WARNING: Sharp blade on cutting attachment
_',_ shield, TO prevent serious injury, do net touch
_l_' the ne cutt ng bade.
SYMBOL MEANING
I • ON/OFF STOP CONTROL
ON / START / RU_
O • ON/OFF STOP CONTROL
OFF or STOP
• HOT SURFACE WARNING
Do not touch a hot muffler, gear housing or
cylinder. You may get burned. These parts get
extremely hot from operation. They remain hot for
a short time after the unit is turned off.
• .. • THROWN OBJECTS AND ROTATING
_w
_ CUTTER CAN CAUSE SEVERE INJURY
/JAr WARNING: Do not operate without the cutting
_/_t_ attach-ment shield in place. Keep away from the
rotating cutting attachment.
A • KEEP BYSTANDERS AWAY
L_',_¢_,'_ WARNING: Keep all bystanders, especially
/_,j_=fi_ children and pets, at least 50 feel (15 m) from
- - the operating area.