Linearization Table - Endress+Hauser RIA250 Manual De Instrucciones

Process display
Parameter
Actual fault
Display address:
Display of actual fault
message
Last fault
Display address:
Display of last fault
message

5.6 Linearization table

The following addresses are only displayed in the setting up
menu if linearization of the input signal has been selected.
Address
Parameter
* Number of points
Enter of the number of
linearization points are to
be allocated.
The number of points can
be inceased at a later
time.
The first and last points are automatically set by the unit and are allocated the values
of sensor scale 0% (
SC H1
( ) to display value 100% (
* Delete all
points
All linearization points are
deleted to allow input of a
new linearization curve.
62
Setting up selections
AERR
Fault code see
Chapter 7
LERR
Fault code see
Chapter 7
CURVE TABLE
is set to
Setting up selections
COUNT
Number:
2 to 32
SC LO
) to display value 0% (
DI HI
).
DEL
YES
All linearization points
are deleted after
acknowledgement
NO
All linearization points
remain unchanged
Default
settings
E 000
E 000
.
Default
settings
2
DI LO
) and sensor scale 100%
NO
Actual
TABLE
Actual