Operation - Fini Advanced AIRBOSS Manual Del Usuario

APPLICATIONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this tool for purposes listed below:
Operating air powered tools requiring less than
1.7 SCFM @ 90 PSI.
Powering pneumatic nail guns, inflating tires, cleaning /
blowing with pressurized air.
USING THE AIR COMPRESSOR
See Figures 6 - 7.
Ensure the tank drain valve is closed (see Fig. 6).
Ensure the ON/OFF switch is in the OFF (O) position
and the air compressor is unplugged (see Fig. 6).
Ensure the pressure regulator knob is turned fully
counterclockwise (see Fig. 6).
If not already installed, attach the hose to the compressor.
Connect the air powered tools to the air hose by
inserting the male quick-connect plug to the quick-
coupler at the end of the hose (see Fig. 7).
Connect the power cord to the power supply.
Turn the ON/OFF switch to the ON (I) position.
Rotate the pressure regulator knob to the desired
line pressure. Turning the knob clockwise increases
air pressure at the outlet; turning the knob
counterclockwise reduces air pressure at the outlet.
NOTE: Before connecting or disconnecting air tools, turn
the regulator knob counterclockwise to stop the flow of air.
Following all safety precautions in this manual and the
manufacturer's instructions in the air tool manual. You
may now use your air-powered tool.
If using an inflation accessory with a quick-connect
fitting, control the amount of air flow with the pressure
regulator knob. Turning the knob fully counterclockwise
will completely stop the flow of air.
NOTE: Always use the minimum amount of pressure
necessary for your application. Using a higher pressure
than needed will drain air from the tank more rapidly
and cause the unit to cycle on more frequently.
When finished, always drain the tank and unplug the unit.
Never leave the unit plugged in and/or running unattended.
WARNING:
Check the air tool manual to insure the correct air pressure
regulator setting for optimum operation of your air tools. If you
are using an air tool not originally included with the air tool kit
supplied with this air compressor, your tool may require more air
consumption than this air compressor is designed to supply.
Always read your air tool owner's manual to match the correct air supply
to your air tool to avoid damage to the tool or risk of personal injury.

OPERATION

WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating power tools. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
CAUTION:
Do not use in an environment that is dusty or otherwise
contaminated. Using the air compressor in this type of
environment may cause damage to the unit.
WARNING:
Always ensure the switch is in the OFF (O) position and the
regulator pressure gauge reads zero before changing air
tools or disconnecting the hose from the air outlet. Failure
to do so could result in possible serious personal injury.
Fig. 7
13
PRESSURE
REGULATOR
KNOB
COIL HOSE WITH QUICK
COUPLER ATTACHED
ON/OFF
SWITCH
DRAIN
VALVE
Fig. 6
PNEUMATIC
TOOL
MALE QUICK-
CONNECT PLUG