Specific Safety Rules - Fini Advanced AIRBOSS Manual Del Usuario

Know your power tool. Read the operator's manual
carefully. Learn its applications and limitations, as well
as the specific potential hazards related to this tool.
Following this rule will reduce the risk of electric shock,
fire, or serious injury.
Drain the tank of moisture after each day's use.
If the unit will not be used for a while, it is best to leave
the drain valve open until such time as it is to be used.
This will allow moisture to completely drain out and help
prevent corrosion on the inside of tank.
Risk of Fire or Explosion. Do not spray flammable
liquid in a confined area. The spray area must be well
ventilated. Do not smoke while spraying or spray where
sparks or a flame is present. Keep compressors as far
from the spraying area as possible, at least 15 feet from
the spraying area and all explosive vapors.
Risk of Bursting. Do not adjust the regulator to result
in output pressure greater than the marked maximum
pressure of the attachment. Do not use at a pressure
greater than the rated maximum pressure of this
compressor.
If connected to a circuit protected by fuses, use
time-delay fuses with this product.
To reduce the risk of electric shock, do not expose to
rain. Store indoors.
Inspect the tank yearly for rust, pin holes, or other
imperfections that could cause it to become unsafe.
Never weld or drill holes in the air tank.
Make sure the hose is free of obstructions or snags.
Entangled or snarled hoses can cause loss of balance
or footing and may become damaged.
Use the air compressor only for its intended use. Do
not alter or modify the unit from the original design
or function.
Always be aware that misuse and improper handling
of this tool can cause injury to yourself and others.
Never leave a tool unattended with the air hose
attached.
Do not operate this tool if it does not contain a
legible warning label.
Do not continue to use a tool or hose that leaks air
or does not function properly.
Always disconnect the air supply and power supply
before making adjustments, servicing a tool, or when a
tool is not in use.
Do not attempt to pull or carry the air compressor
by the hose.
Your tool may require more air consumption than
this air compressor is capable of providing.

SPECIFIC SAFETY RULES

Always follow all safety rules recommended by the
manufacturer of your tool, in addition to all safety
rules for the air compressor. Following these rules
will reduce the risk of serious personal injury.
Never direct a jet of compressed air toward people
or animals. Take care not to blow dust and dirt
towards yourself or others. Following this rule will
reduce the risk of serious injury.
Protect your lungs. Wear a face or dust mask if the
operation is dusty. Following this rule will reduce the
risk of serious personal injury.
Do not use this air compressor to spray chemicals.
Your lungs can be damaged by inhaling toxic fumes. A
respirator may be necessary in dusty environments or
when spraying paint. Do not carry while painting.
Inspect tool cords and hoses periodically and, if
damaged, have repaired at your nearest Authorized
Service Center. Constantly stay aware of cord
location. Following this rule will reduce the risk of
electric shock or fire.
Never use an electrical adaptor with this grounded
plug.
Check damaged parts. Before further use of the
air compressor or air tool, a guard or other part
that is damaged should be carefully checked to
determine that it will operate properly and perform
its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of
parts, mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or replaced
by an authorized service center. Following this rule
will reduce the risk of shock, fire or serious injury.
Make sure your extension cord is in good
condition. When using an extension cord, be sure
to use one heavy enough to carry the current your
product will draw. A wire gauge size (A.W.G.) of at
least 14 is recommended for an extension cord 50
feet or less in length. A cord exceeding 100 feet is
not recommended. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier
the cord. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
WARNING:
The brass components of this product contain lead, a
chemical known to the state of California to cause birth
defects (or other reproductive harm).
(California health & safety code § 25249.5, et seq.)
Save these instructions. Refer to them frequently
and use them to instruct others who may use this air
compressor. If you loan someone this tool, load them
these instructions also.
5