Connection To Your Personal Computer (Macintosh) - NEC MultiSync LCD1510 Manual De Usuario

Installation

Connection to your Personal Computer (Macintosh)

With the Macintosh cable adapter, the MultiSync LCD
/ LCD colour monitor is compatible with the Macintosh family of
2010
computers. You will connect your MultiSync colour monitor one of
two ways to your Macintosh computer:
– On-board video port1
– NuBus/PCI/PDS display card
Both configurations should have the same style video connector. If you
are not sure which port is the monitor connector, please reference your
computer or display card manual.
To attach your MultiSync LCD monitor to your system, follow these
instructions:
1. Turn off the power to your MultiSync LCD monitor and
Macintosh.
2. If neccssary, install the display card. For more information on
this installation, reference the display card manual.
3. Connect the MultiSync LCD
MultiSync LCD
(Figure B.1). Attach the 15-pin mini D-SUB end of the
appropriate signal cable to the MultiSync LCD
LCD
1510V
(Figure B.1). Tighten all screws.
4. For the MultiSync LCD
the 15-pin mini D-SUB of the video signal cable and the AC
Adapter cable to the appropriate connectors on the back of the
monitor (Figure C.1).
For the MultiSync LCD
of monitor. Connect the BNC cables and AC adapter cable to
the appropriate connectors on the back of the monitor. Connect
the red BNC cable to the BNC connector on the monitor labeled
R, the green BNC cable to the BNC connector labeled G/Sync,
the blue BNC cable to the BNC connector labeled B. If you
have a fourth BNC connector (Composite Sync), connect it to
Macintosh cable adapter to the computer
2010
or MultiSync LCD
1510
: Remove connector cover on back
2010
1510
, MultiSync LCD
1510
Macintosh cable adapter
2010
, MultiSync LCD
E - 11
/ LCD
1510V
or
1510V
, MultiSync
1510
: Connect
1510V