Cover Plate - Makita XVJ01 Manual De Instrucciones

Installing or removing saw blade
CAUTION:
• Always clean out all chips or foreign matter
adhering to the blade and/or blade holder.
Failure to do so may cause insufficient tighten-
ing of the blade, resulting in a serious personal
injury.
• Do not touch the blade or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
• Tighten the saw blade securely. Failure to do so
may cause a serious injury.
• When you remove the saw blade, be careful not
to hurt your fingers with the top of the blade or
the tips of workpiece.
► 1 . Fixed position 2. Released position
Before installing the blade, make sure that the blade
holder is in the released position.
To install the blade, insert the blade (teeth facing for-
ward) into the blade holder until it latches. The blade
holder moves to the fixed position by itself and the
blade is locked. Pull the blade lightly to make sure that
the blade does not fall off during operation.
CAUTION:
• Do not open the tool opener excessively, or it
may cause tool damage.
1
► 1 . Jig saw blade
To remove the blade, push the tool opener forward as
far as it will go. This allows the blade to be released.
NOTE:
• Occasionally lubricate the roller.
Hex wrench storage
1
► 1 . Base 2. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.

Cover plate

1
2
► 1 . Cover plate 2. Base
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
Anti-splintering device
► 1 . Anti-splintering device 2. Base
For splinter-free cuts, the anti-splintering device can be used. To
install the anti-splintering device, move the tool base all the way
forward and fit it from the back of tool base. When you use the
cover plate, install the anti-splintering device onto the cover plate.
8 ENGLISH
2
1
2
2
1