Dust Extraction - Makita XVJ01 Manual De Instrucciones

CAUTION:
• The anti-splintering device cannot be used when
making bevel cuts.

Dust extraction

The dust nozzle (optional accessory) is recommended
to perform clean cutting operations.
► 1 . Dust nozzle 2. Base
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
1
► 1 . Clamp screw
To secure the dust nozzle, tighten the clamp screw at
the front of the dust nozzle.
The dust nozzle can be installed on either left or right
side of the base.
1
► 1 . Dust nozzle 2. Hose for vacuum cleaner
Then connect a Makita vacuum cleaner to the dust nozzle.
1
2
2
OPERATION
CAUTION:
• Always hold the base flush with the workpiece.
Failure to do so may cause blade breakage,
resulting in a serious injury.
NOTE:
• If the tool is operated continuously until the
battery cartridge has discharged, allow the tool
to rest for 15 minutes before proceeding with a
fresh battery.
1
► 1 . Cutting line 2. Base
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest
the base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
When cutting curves, advance the tool very slowly.
Bevel cutting
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before tilting
the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
9 ENGLISH
2