Service; Operation - Smithco SweepStar 48 Manual Del Usuario

OPERATION

Before operating this machine, become familiar with all controls and functions of these units. Also complete all
maintenance requirements and read all safety warnings. By knowing the machine thoroughly, how it operates
and by doing the prescribed maintenance steps, you can expect relatively trouble-free operation for years to
come.
Beater reel MUST BE DISENGAGED before starting engine.
STARTING GAS ENGINE
1. Make sure the fuel flow valve, located on the fuel tank, is "ON."
2. The ignition switch is located on control panel. Insert key (A) and turn
clockwise until engine starts (C). Release key and it will return to run
position (B). Use choke and hand throttle as necessary.
3. Allow engine to idle and warm up a few minutes before selecting a direc-
tion of travel.
STARTING DIESEL ENGINE
1. Make sure the fuel flow valve, located on the fuel tank, is "ON." Also the
fuel valve, located on the fuel filter, is "ON."
2. Pull the stop knob out, located on the control panel.
3. Place the speed control lever at more than half "Operation."
4. Insert the key (A) into the key switch and turn it to "ON" (B). Check to see
if the oil pressure lamp and charge lamp are lit.
5. Turn the key counter clockwise to "preheat" (D) until the indicator lamp on
the control panel goes out.
6. Turn the key clockwise to "Start" (C). When engine starts, release the key
immediately. Do not hold the key in the "Start" position for more than 10
seconds.
7. Check to see that the oil pressure and charge lamps are off. If the lamps are still on, immediately stop the
engine (push the stop knob in) and determine the cause.
8. Warm up the engine at medium speed without load.
TAILGATE LEVER
Tailgate tends to creep open while sweeping. Frequently close the
tailgate to ensure no creeping.
SWEEP STAR 60 ACCELERATOR/REVERSE PEDAL
On the right floorboard of the Sweep Star 60 is a "rocker" pedal.
Push down on the front (G) with your foot and the machine will
accelerate. Push down on the rear of the pedal (H) with the heel of
your foot and the machine will go in reverse. The machine is in
neutral when foot is off the pedal.
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
14