Publicidad
Idiomas disponibles
Idiomas disponibles
SWEEP STAR 48H ACCELERATOR/REVERSE PEDAL
On the right floorboard of the Sweep Star 48H is the accelerator
pedal (J) and the reverse pedal (K). The machine is in neutral when foot is
off the pedal.
DAILY CHECKLIST
1. Check park brake adjustment. Adjust as required.
2. Check engine oil level. Add as needed. DO NOT OVERFILL.
3. Tire pressure should be 20 psi (1.4 bar) on all Sweep Star 48 tires
and castor wheels. Tire pressure should be 20 psi (1.4 bar) on
Sweep Star 60 front tire and castor wheel, 18 psi (1.3 bar) on rear
tires.
4. Inspect electrical system for loose connections or frayed wiring,
including battery cables. Replace any faulty equipment or tighten if
loose.
5. Check hardware for loose or missing nuts, bolts, screws, etc., and tighten or replace as needed.
6. Inspect hydraulic lines for damage or leaks. Never use hands to inspect leaks.
7. Check hydraulic oil level in right side tank. The level should be 2" to 2
fluid is cold. If level is low, add SAE 10W-40 API Service SJ or higher motor oil.
8. Inspect steering, throttle and shift linkages for good hookups and clear travel.
9. Check controls for smooth, proper working operation. Lubricate as needed.
10. Check and clean all debris from engine compartment.
HOPPER LIFT SAFETY ARM
Each machine is equipped with two Hopper Lift Safety Bar.
They are stored on the Hopper Dump arms, on each side of the
hopper, with two bolts and wing nuts. See Picture 1.
The purpose of the Hopper Lift Safety Bar is to help the hopper
lift cylinders hold the hopper in the up position. The weight of
the hopper can cause the cylinders to retract. Bolt the Hopper
Lift safety bar around the cylinder shaft to prevent the hopper
from slowly lowering due to gravity. See Picture 2.
Picture 2
PARTS MANUALS AVAILABLE ONLINE AT smithco.com
OPERATION
1
/
" (5-6.4 cm) from top of tank when
2
Picture 1
15
Publicidad
Capítulos
