Quick Start - Olivetti ECR 5500 Guía De Referencia Rápida

Quick Reference Guide

QUICK START

Unpack the cash register and place it on a level, stable, vibration-free and dust-free surface near a grounded
power outlet.
Plug the cash register into the power outlet and then insert three charged "AA" size memory backup batteries in the
battery compartment as explained in the section Inserting/Replacing Batteries of the Instructions Manual. During
cash register operation, all transaction data for the management report are stored in the register's memory. This
memory also holds all optional programming information. The memory back-up battery system keeps this
information stored in memory when the cash register is turned off or when a power failure occurs. All data stored
in memory will be canceled if you unplug the cash register from the electrical wall outlet without back-up
battery supply.
Load the standard roll of thermal paper tape as explained in the related section of the Instructions Manual.
1. SET THE DATE
1. Open the printer compartment cover and slide the control switch to the PRG position.
2. Type the [numeric keys] representing the current date. Use the DDMMYY format. Single digit numbers for
months and days must be preceded by a zero (0).
3. Press the [#/NS] key to store the date.
4. Program another feature or exit the program mode by sliding the control switch to the OFF position.
Example: Set a date of September 29, 2003.
Type/Press:
[290903] + [#/NS]
NOTE: If you wish that the date just entered be printed in the month/day/year format, type [70] and then press
the [RA/FC] key.
2. SET THE TIME
1. Open the printer compartment cover and slide the control switch to the PRG position.
2. Type the [current time] using the HH:MM format. Time is set according to international, or military time (24-
hour clock format). To correctly enter this time, simply add 12 to all hours in the PM. For example, to set the
time to 9:00 AM, type [0900]; to set the time to 2:15 PM, type [1415].
3. Press the [Qty/Time] key to store the entered time.
4. Program another feature or exit the program mode by sliding the control switch to the OFF position.
Example: Set the time at 3:30 PM.
Type/Press:
[1530] + [Qty/Time]
NOTE: If you wish that the time just entered be printed and displayed in the 24-hour format, type [40] and then press
the [RA/FC] key.
1