Satellite - AXIL RS 0761 HD Manual Del Usario

and press RIGHT/LEFT to adjust the settings. Press EXIT to exit the Menu

4.3.1 Satellite

Configure the settings of satellites.
Satellites' list: Press Up/Down to select a satellite, whose settings will be shown at right
side.
LNB Type: Press LEFT/RIGHT/OK to show the list of LNB Types which is shown as
frequencies of local oscillator. You also can enter frequency by User Single, User Dual at
bottom of the list.
LNB Power: Press LEFT/RIGHT to set the LNB power.
22K: Press Left/Right to switch on or off the 22K,which is set with auto when LNB Type is
dual local oscillator.
Toneburst: Enable or Disable the toneburst switcher.
DiSEqC1.0: select the right port up to 4 for the right LNB.
DiSEqC1.1: select the right port up to 16 for the right LNB.
Motor: Press LEFT/RIGHT to select DiSEqC1.2 or DiSEqC1.3. Then Press OK to show the
menu to set position.
DiSEqC1.2: Move the motor to a right position to lock the signal.
DiSEqC1.3: Move the motor according to the local and satellite positions.
Move Auto: Press LEFT/RIGHT to start to move West/East. It will be stopped automatically
when the signal is locked.
Move Continue: Press LEFT/RIGHT to start to move West/East. It will keep moving until
you stop it.
Move Step[1]: Press LEFT/RIGHT to move just a step.
Store Position: store current position of motor.
Goto Position: Press LEFT/RIGHT to goto the position stored.
Goto Reference: Rest all the positions.
Goto X: goto the position calculated from the local and satellite positions.
Add satellites: Press Red to add a new
satellite, in which you must input an unique
longitude, and edit the satellite's name with
soft keyboard.
Edit satellites: Press Green to edit the
focused satellite.
Delete satellite: Press Yellow to delete the
focused satellite. Press OK to confirm.
Single Satellite Scan: Press Blue to pop
the
menu of scanning settings.
Scan Mode: Press Left/Right to select
default, which scan the default
transponders built in, Blind Scan and
NetWork, which scan with NIT on.
Crytped: Press Left/Right to select All
Channels or FTA Channels;
Service Type: Press Left/Right to select
ALL , DTV or Radio.
Press OK to start scanning with the above
settings.
Multi-Satellites Scan: Press OK to select satellites with the mark" ü ",then press
5