Publicidad
Idiomas disponibles
Idiomas disponibles
User's Guide
English
screwing the rack bit by bit firmly in position. In this way, you ensure that the gear
rack engages with the cog wheel in an optimum manner. While doing this, do not
forget to mark each fixing point. (Fig.2) There is a gap of approx. 2mm between the
cog wheel and the gear rack bar.
Fig. 2
V. Gate operator release mechanism (manual operation)
The gate operator is equipped with a lockable release mechanism to enable the gate to
be operated manually in a power cut. The release mechanism is shown in Fig.3 and
Fig.4 with the clutch disengaging the link between the cog wheel and the gear.
Fig.3 (
)
RELEASE THE MOTOR
VI. Fitting limited switches (to gate)
Fit the localizers of spring limited switch/magnets and their brackets on to the gear
Tecnomatic: www.tecnomatic –systems.com
16 16
Publicidad
