Publicidad
Idiomas disponibles
Idiomas disponibles
Control Board Installation
English
Motor run timer:
The potentiometer labeled (RF3) is for normal speed timer and labeled (RF4) for slow speed timer.
Timer is from 2 seconds to 70 seconds. Clockwise rotate increase the time. Counter clockwise
rotate decrease the time. Turn off the power, wait for a moment (2 seconds).Turn on the power to
enable the adjustment.
Remote Push Button Select:
To select NO.1 push button you must flip the rocker arm (position 4) to the ON position in the
switch (SW2). The button will cycle from open to stop and close
To select NO.2 push button you must flip the rocker arm (position 3) to the ON position in the
switch (SW2).The button will cycle too.
To select NO.4 push button you must flip the rocker arm (position 2) to the ON position in the
switch (SW2).The button is close only.
To select NO.3 push button you must flip the rocker arm (position 1) to the ON position in the
switch (SW2).The button is open only.
Limit switch N.C./N.O. Selector:
The position 4 in the switch (SW1) is limit switch N.C./N.O. selector.
Limit switch is N.O. you must flip the rocker arm (position 4) to the OFF position in the (SW1)
Limit switch is N.C. you must flip the rocker arm (position 4) to the ON position in the (SW1)
Turn off the power, wait for a moment (2 seconds) than turn on the power to enable the selection.
Left/right Hand Selector:
The position 3 in the switch (SW1) is L/R hand selector
Left hand place, you must flip the rocker arm (position 3) to the OFF position in the switch (SW1)
Right hand place, you must flip the rocker arm (position 3) to the ON position in the switch (SW1)
Change the position 3 in the switch (SW1) can change the open direction and close direction. Turn
off the power , wait for a moment (2 seconds ) than turn on the power to enable the selection.
Auto Close Timer:
(position 1 and position 2) in the switch (SW1) is use for auto close timer
To enable the auto close timer, you must flip the rocker arm (position 1or position 2) to the ON
position in the (SW1). Position 1 to on is 20 seconds. Position 2 to on is 10 seconds. Position 1
and position 2 together to on is 30 seconds.
To disable the auto close timer, you must flip the rocker arm (position 1 and position 2) to the OFF
position in the (SW1)
Turn off the power, wait for a moment (2 seconds) than turn on the power to enable the selection.
Learn The Remote:
Press the code button on the board for 1 second, release the learn button, then press the transmitter
for 1 second and release. The remote has been learned.
Erase The Remote:
Keep pressing the learn button on the receiver for 20 second, release the learn button. All remote
has been erased.
20
Publicidad
