Peavey XXL 212 Combo Manual De Instrucciones página 7

Idiomas disponibles

R R e e a a r r P P a a n n e e l l

( ( 1 1 9 9 ) )

R R E E M M O O T T E E S S W W I I T T C C H H

This seven-pin DIN connector is provided for connection of the footswitch. The footswitch

cable should be connected before the amp is powered up. See the FOOTSWITCH section of

this manual for explanation of footswitch operation.

( ( 2 2 0 0 ) )

E E F F F F E E C C T T S S L L E E V V E E L L S S W W I I T T C C H H

Selects the effects loop operating level: -10 dBV (0.3V RMS) when "out" and 0 dBV (1 V RMS)

when "in."

( ( 2 2 1 1 ) )

E E F F F F E E C C T T S S S S E E N N D D

Output for supplying signals to external low-level effects or signal processing equipment.

( ( 2 2 2 2 ) )

E E F F F F E E C C T T S S R R E E T T U U R R N N

Input for returning signals from external low-level effects or signal processing equipment.

( ( 2 2 3 3 ) )

P P R R E E A A M M P P O O U U T T

The preamp out can be used to route the amplified signal from the preamp to a mixing

console, tape recorder, etc. Connect the preamp output to line-level inputs of other equipment

using high quality shielded cable. This patch does not affect operation of the amplifier.

( ( 2 2 4 4 ) )

P P O O W W E E R R A A M M P P I I N N

Used to connect line-level signals to the XXL 212 COMBO's power amplifier section. Connect

the power amp input to line-level output of other equipment using high quality shielded cable.

This patch disconnects the XXL 212 COMBO preamp section from the power amp section.

( ( 2 2 5 5 ) )

D D A A M M P P I I N N G G

This three-position switch allows for adjustment of the damping factor of the power amplifier.

Damping is the ability of an amplifier to control speaker cone motion after the signal

disappears. A higher damping factor (TIGHT) reduces cone vibration more quickly than a

lower damping factor (LOOSE). This switch works much like the Resonance and Presence

controls found on other Peavey amps, if they were to be turned simultaneously. If the

Damping switch is changed, the volume level of the amp will also change and may require

re-adjustment of the Master Volume (3).