Publicidad
Idiomas disponibles
Idiomas disponibles
( ( 2 2 6 6 ) )
P P O O W W E E R R
This three-position switch selects the power output level of the power amplifier. This switch
works like the T. Dynamics
more pronounced tube power compression simulation at lower settings.
( ( 2 2 7 7 ) )
S S P P E E A A K K E E R R O O U U T T P P U U T T S S
These paralleled
1
⁄
Minimum speaker impedance is 4 Ohms. The CABINET IMPEDANCE switch (28) must be set to
match the load of the speaker cabinet(s).
( ( 2 2 8 8 ) )
C C A A B B I I N N E E T T I I M M P P E E D D A A N N C C E E
This three-position switch allows for appropriate selection of speaker cabinet impedance. If
two enclosures of equal impedance are used, the switch should be set to half the individual
value. For example, two 16 Ohm enclosures necessitate an 8 Ohm setting, while two 8 Ohm
enclosures would require a 4 Ohm setting. Minimum speaker impedance is 4 Ohms. This
switch should be set to 16 Ohms when no external cabinet is connected.
( ( 2 2 9 9 ) )
G G R R O O U U N N D D P P O O L L A A R R I I T T Y Y S S W W I I T T C C H H
This three-position rocker switch should normally be placed in the center (0) position. If hum
or noise is noticed coming from the speaker enclosure(s), the switch may be placed in the "+"
or "-" position to minimize hum and noise. If changing the polarity does not alleviate the
problem, consult your authorized Peavey dealer, the Peavey factory, or a qualified service
technician.
( ( 3 3 0 0 ) )
I I E E C C M M A A I I N N S S C C O O N N N N E E C C T T O O R R
This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and
ratings for the intended operating voltage is included in the carton. The mains cord should be
connected to the amplifier before connecting to a suitable AC outlet.
®
control found on other Peavey amplifiers which provides for a
" mono (TS) jacks are provided for the connection of speaker enclosure(s).
4
8
Publicidad
