GRE HIMFILTROS.14 Manual De Instalación Y Mantenimiento página 3

INSTRUCTIONS FILTRE MONOBLOC
Read manual carefully and keep it in a safe place for future reference.
This manual covers the filtration group which is described (name and reference) in the attached document "TECHNICAL
CARACTERISTICS".
• All electrical installations should comply with the following standard:
As such with all rules pertaining to "to the construction of electrical installations within specific confines: swimming pools and
fountains", or the equivalent standard in force in each region or country.
• The electrical installation should be done by someone qualified in working with electrical equipment. This equipment is not
designed for those with physical, sensory or mental handicap or people lacking in experience, unless done under supervision or
with instructions of use from a person in charge of safety.
• The height of the sand should not exceed 2/3 of the height of the tank.
• It is important to check that the suction ports are not blocked.
• Check regularly the filter level of dirtiness.
• The equipment must not be switched on while the pool is being used.
• Do not operate the equipment unless it is properly primed.
• NEVER touch the filter when it is operating if you are wet or have wet hands.
• When handling the filter or valve, DISCONNECT the power supply.
• Make sure that the ground is dry before touching the electrical equipment.
• Do not submerge the equipment or put it in a place where it could be submerged.
• Do not permit children nor adults to sit or lean on the equipment. Children should be supervised to ensure that they do not play
with the equipment.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order
to avoid a hazard.
• It is essential that any damaged element or set of elements is changed as soon as possible. Only use parts that are approved by
the sales representative.
• The equipment should be connected to a power supply (see data on the pump's plate), with earth connection, protected by a
residual current device (RCD) having a rated residual operating current not exceeding 30 mA. or by an insulating transformer.
• Forbid access to the pool if any damage of the filtration system(s) occurs.
• Where chemical products are used to treat the pool water, it is recommended that a minimum filtration time is respected in order
to protect bathers' health, as stated by the health regulations.
1 PACKING COMPONENTS
The equipment which you have just purchased is a special apparatus conceived and designed especially for above ground
swimming pools. As a result of its innovative design and high level of functionality, it provides you with the different components
required to filter water: filter, pump and selector valve in a single unit. The main components of this filter are as follows:
Some of the equipment's accessories (silica sand, hoses, manometers...) are not included in all models of monoblocs.
Installation and General Maintenance Manual
European Low Voltage Directive 2006/95/CE,
EN 60335-2-41, safety of household or similar electrical appliances, particular requirements for pumps.
FIG.
1
1
1
1
1
1
1
- POOL PUMPS
POS.
1A
1B
1C
2
3
4
5
NAME
4 functions valve
5 functions valve
6 functions valve
Filter
Monobloc base
Conection hose valve-pump
Pump
3