Oase Water Trio Garantia, Instructivo De Seguridad Y De Operaciones página 11

Pos: 33 /Lampen/Wasserspieltechnik/Water-Trio/Quintet USA/Inbetriebnahme Water Trio-Quintet USA @ 10\mod_1235481349777_121.doc @ 60454 @
Start-up
Caution! Do not damage the unit.
Protective measures: Never run the unit without water.
The unit switches on automatically when connected to power. Attention: Note DC +/- polarity.
Switching on the unit (I): Plug the power plug (22) of the transformer into the socket.
− The Water Trio / Water Quintet starts with program 1 (see chapter Operation).
Switching off the unit (I): Disconnect the power plug (22) of the transformer.
Pos: 34 /Alle Produkte/Überschriften/H1 Bedienung @ 7\mod_1196625148604_121.doc @ 41443 @
Operation
Pos: 35 /Lampen/Wasserspieltechnik/Water-Trio/Quintet USA/Bedienung Water Trio-Quintet USA @ 10\mod_1235481766531_121.doc @ 60483 @
Pos: 36 /Lampen/Wasserspieltechnik/Water-Trio/Quintet USA/Handsender einlernen Water Trio-Quintet USA @ 10\mod_1235482195003_121.doc @ 60510 @
The manual transmitter as part of our scope of delivery is taught in for the 12 V control box. The 12 V control box has
to be adapted to every further manual transmitter.
Teaching-in manual transmitter (J):
The receiver is equipped with a teach-in button (24) to adapt the 12 V control box to the transmission signal of the
manual transmitter.
− Insert a pin (23) into the opening for the teach-in button (24) until you feel a resistance. Keep pressing in the pin (23)
until this resistance is overcome. The teach-in button (24) is then activated.
− Actuate the teach-in button (24) using the pin (23) for approx. 1 sec.
− Press any button of the manual transmitter for at least 1 sec.
Deleting the manual transmitter (J):
− Actuate the teach-in button (24) using a pin (23) for at least 5 sec.
This deletes all manual transmitters stored in the receiver.
Note: A maximum of 10 manual transmitters can be set to the receiver. The manual transmitter has a maximum range
of 80 m (260 ft). Obstacles between transmitter and receiver, a low battery in the manual transmitter, or electro-
magnetic radiation of electrical equipment will impair the range.
Pos: 37 /Lampen/Wasserspieltechnik/Water-Trio/Quintet/Ausrichten Düsen Water Trio/Quintet @ 8\mod_1219935402024_121.doc @ 51269 @
− Aligning the water jet (K):
− Adjust the individual movable nozzles to align the water jet (5).
Pos: 38 /Alle Produkte/Dummy_module/===== Seitenwechsel ===== @ 0\mod_1125648978015_0.doc @ 1631 @
The manual transmitter can be used to select 9 programmed water feature patterns.
Program 1 appears automatically when starting up and with each new start of the unit.
P0 Unit off, stand-by mode
P1 All fountains active, fixed height up to max. 30 cm (1 ft)
Light on for all fountains
P2 All fountains active, fixed height up to max. 70 cm (2,3 ft)
Light on for all fountains
P3 All fountains active, dynamic fountain height, max. 70 cm (2,3 ft) high
Light on for all fountains
P4 One fountain each alternatingly active in intervals, max. 70 cm (2,3 ft) high
Light switched on for each active fountain
P5 All fountains active, fixed height up to max. 110 cm (3,6 ft)
Light on for all fountains
P6 All fountains active, dynamic fountain height, max. 110 cm (3,6 ft) high
Light on for all fountains
P7 One fountain each alternatingly active in intervals, max. 140 cm (4,6 ft) high
Light switched on for each active fountain
P8 All fountains active, dynamic fountain height, max. 140 cm (4,6 ft) high
Light on for all fountains
P9 Several fountains alternatingly active, max. 140 cm (4,6 ft) high
Light switched on for the respective active fountains
Select next program: Button 1
Select previous program: Button 2
Note:
− Program 1 always starts when Water Trio / Water Quintet is switched on by a timer.
− Fountain heights can be varied.
- English -
11