Operation - Dimplex DWOP20R Manual De Instrucciones

Operation

Figure 9
B
!
NOTE: When the engine is
used in an environment where
background noise is very low, it
may be possible to hear a sound
which is related to the operation
of the flame effect. This is normal
and should not be a cause for
concern.
!
NOTE: Always ensure that
the appliance is fixed to the wall
in a level position.
The manual controls for the wall
mount engine are located on the
bottom of the unit. (Figure 9)
A. On/Off Switch
Supplies power to the engine.
B. Thermostat Control
To adjust the temperature to your
individual requirements, turn the
thermostat control backwards
all the way to turn on the heater.
When the room reaches the
2kw
A C
D
desired temperature, turn the
thermostat knob forward until you
hear a click. Leave thermostat in
this position to maintain the room
temperature at this setting. For
additional heat, turn clockwise
until you hear the click again and
the heater will turn on.
C. Mode Selector Switch
Press once to turn on the flame
effect. This will be indicated by an
audible "beep". Although the lights
turn on immediately it will take 30
seconds before the flame effect
starts.
• Press again to give flame ef-
fect and full heat. This will be
indicated by two "beeps".
• Press again to return to flame
effect only. This will be indi-
cated by one "beep".
• Press to put fire in to
11