Controls & Operation - Cub Cadet JS 1150 Manual Del Operador

Controls & Operation
Engine
Blower
Housing
Caster
Wheel
Lock
Figure 4-1
Controls
WARNING! Read and follow all
safety rules and instructions in
this manual before attempting to
operate this machine. Failure to
comply with all safety rules and
instructions may result in personal
injury.
The controls and features of your jet sweep
blower are illustrated in Figure 4-1.
Engine
Refer to the Engine Operator's Manual for
details regarding all engine-related controls
and features.
Caster Wheel Lock
The front caster wheel can be locked in
position for straight ahead travel or allowed to
swivel freely. See Figure 4-2. Refer to Locking
the Caster Wheel in Operation Section.
Figure 4-2
Discharge Chute
The discharge chute is located on the left side
of the jet sweep and directs the air flow.
Blower Direction Lever
The air flow can be directed to one of three
directions using the blower direction lever to
reposition the louvers. See Figure 4-3.
WARNING! Do not stand in front
of discharge area.
6
BLOWER DIRECTION LEVER
Operation
Blower
Starting & Stopping the Engine
Direction
Lever
Refer to the Engine Operator's Manual for
instructions on starting and stopping the
Discharge
engine.
Chute
Adjusting the Blower Direction
The air flow can be directed to one of three
directions using the blower direction lever to
move the louvers.
NOTE: The blower direction lever must be
in the middle position when operating the
blower with the chute attachment to keep it
locked in place.
1. Pull the lever out and away from the
blower. See Figure 4-4.
2
2. Move the lever to the left to direct
airflow downward or to the right to
direct airflow upward.
3. Release lever towards blower, making
sure it secures into place.
WARNING!
operating blower. Do not allow the
directional discharge chute to point
in the direction of bystanders or
pets.
Attaching the Chute Attachment
WARNING!
without shields and guards in
place.
To redirect airflow at a 90° angle during
operation, a chute attachment is included with
your jet sweep blower.
Figure 4-3
1
Blower Direction
Lever
Louvers
Side view
Figure 4-4
Exercise caution when
DO NOT operate
1. Pivot the blower direction lever all the
way to the right, into the highest position.
See Figure 4-5.
2
1
Figure 4-5
2. Slide the chute attachment downward,
over the opening.
3. Pivot the direction lever to the middle
position to lock the chute attachment in
place. See Figure 4-5.
4. To remove the chute attachment, first repeat
step 1, then slide the chute attachment
upward and off the chute.
WARNING!
Keep hands out of
inlet and discharge openings
while machine is running. There
are rotating blades inside.
Locking the Caster Wheel
1. To lock the caster, lift the lock pin and
rotate it rearward, releasing it into the
larger hole. See Figure 4-6.
A
B
Figure 4-6
2. To unlock the caster, lift the lock pin and
rotate it forward, releasing it into the
smaller hole.
4
3